Parameter of vortex flow meter
Measured  Mediums	Liquids, Gases and Steams  (NOTE: the mediums should be unidirectional or can be seen as unidirectional.)
	When the dryness of saturated steams ≥ 85 , they can be seen as unidirectional.
Temperature  of Mediums	- 40°C ~ + 350°C
Pressure  of Mediums	1.6MPa, 2.5MPa, 4.0 MPa
Accuracy	1.0; 1.5
Span Rate	1:8 ~ 1:30 (compared with the standard atmospheric pressure)
	1:8 ~ 1:40  ( compared with the nominal temperature water)
Flow Range	Liquids: 0.4 ~ 7.0 m/s
	Gases: 4.0 ~ 60.0 m/s
	Steams: 5.0 ~ 70.0 m/s
Nominal Diameter	DN 25, 40, 50, 65, 80, 100, 125, 150, 200, 250,300 mm
Materials	1Cr18Ni9Ti
Reynolds No.	Normally, 2*104 ~ 7*106
Resistance  Coefficient	Cd ≤ 2.6
Licensed Vibration  Acceleration	LUGB type ≤ 0.2g
Class of Protection	IP65
Class of  Explosion-Proof	Intrinsically Safe Explosion-Proof: Exia II CT2 ~ CT6
	Explosion Suppression: Exid II CT4
Conditions  of Surroundings	Temperature of  Surroundings:		Non-Explosion Proof  Surroundings : - 40°C~ +55°C
			Explosion-Proof  Surroundings : - 20°C~ +55°C
	Relative Humidity:		≤ 85%
	Atmospheric Pressure:		86 ~ 106 kPa
Power Supply	Non-Explosion Proof  Type	Pulse  type:	+12 VDC  Output : 4~20mA
		Current  type:	+24 VDC  Output : 4~20mA
	Explosion - Proof Type	Current  type:	+24 VDC  Output : 4~20mA )
Output Signal	Frequency pulse signal 2~3000Hz,  low level voltage ≤1V, high level voltage ≥ 6V
	Two-wire system 4 ~ 20mA Signal (isolation output), load ≤ 500Ω.

 

Measure range of vortex flow meter
Diameter (mm)	Water	Gases in the Normal Temperature and Pressure
	Range of Standard Measurement (m3/h)	Range of Standard Measurement (m3/h)
25	2 ~ 16	8~60
32	1.5~15	14~100
40	3~30	18~180
50	4~40	30~300
65	6~60	50~500
80	13~130	70~700
100	20~200	100~1000
125	36~360	150~1500
150	50~500	200~2000
200	100~1000	400~4000
250	150~1500	600~6000
300	200~2000	1000~10000